裝載機離合器使用注意事項
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：893次
裝載機離合器需要定期清潔殼體，檢查調整分離間隙、定期注入潤滑脂，必要時清洗摩擦片上的油漬，必須正確使用妥善保養。
1、在安裝裝載機離合器時，應在分離軸承內腔填滿鈣基潤滑脂，本機分離軸承外部設有黃油嘴，應定期限量地注入凡士林(黃油)。分離離合器時，動作要迅速，并徹底分離。
When you install the loader clutch release bearing cavity should fill in the calcium-based grease, this machine has a separate exterior bearing grease fittings should be periodically injected Limited Vaseline (butter). When the clutch, action should be promptly and thoroughly separated.
2、接合離合器時，應緩慢放松踏板，使之柔和平穩地接合。應先用定位心軸插入軸承內，以使主、副摩擦片總成的花鍵孔與飛輪同心，便于變速器總成的連接安裝。
When engaging the clutch pedal should be slow to relax so soft smooth engagement. Should be used to locate mandrel inserted into the bearing, so that the primary and secondary friction plate spline hole assembly concentric with the flywheel for easy connection to install transmission assembly.
3、離合器分離時間不宜過長，一般不超過15-20s。
Clutch time not too long, usually no more than 15-20s.
4、控制車速不要用離合器半分離的辦法，以免摩擦片和分離軸承迅速磨損。同時，在行駛時，不要把腳放在離合器踏板上。
Do not control the speed of separation clutch half way in order to avoid friction plate and release bearing rapid wear. Also, when traveling, do not put your foot on the clutch pedal.
